First, cut the workpiece slightly larger than the desired size (adding 25 mm in length, 6 mm in width and 3 mm in thickness)
With the help of a strict-raismus machine, sharpen the front side, making several aisles until it becomes perfectly flat (see. PLANING). The protective fence must be in the working position, move your hands above it, applying the workpiece. On the placed surface, put the front side label with a pencil
Now set the emphasis under 90 degrees and rebuild the front edge evenly and at a right angle with a pencil, make a mark of the front edge
Put a flight table on the width of the workpiece and serve it to the machine. Several passes will be required, use the control mechanism to adjust
In conclusion, install the flight table for the thickness of the workpiece and make several passes in order to step by stages to the material to the desired size. If the board is wide, then with the help of a steel ruler and a marginal knife, pencil or ballpoint hand, mark the parallel line. Shake the withdrawal and strict to line. Measure the exact length and mark it with a pencil then drink excess on the cutting machine, end saw, and t. p.