If you are very often at the summer cottage, then it will not be difficult for you to make a summer shower with your own hands, the water in which will heat up naturally with the help of the sun. However, for this it is necessary to buy lumber from which the walls of the shower will be erected.
For this you will need:
– Building material for walls;
– Capacity;
– Pillars;
– Tes;
– Slate or iron for the roof;
– Shower mixer;
– Crushed stone;
– Sand;
– Cement;
– Nails;
– Sewer pipe.
Instructions.
1. In the construction of a summer shower, the main shower is the installation of strong poles, make a crate, roof and install a container on it. The walls of the soul can be covered with anything, even with matter or cellophane.
2. Digger four pits under the pillars. If they are wooden, then the part that will be treated with mastic in the ground in order to protect the pillar from decay. When installing, use the plumb line to put the pillars evenly. To strengthen around the pillar, pour in small gravel.
3. Dig a small recess along the entire perimeter of the future shower. Install the drain pipe. Put the formwork and cement it. The solution is prepared as follows: 1 part of the cement, and three parts of the sand and crushed stone. Before filling, fill up the bottom of the gravel and align it. The drain pipe must be closed until the solution dries up.
4. Install the crate on pillars in three places from above, in the middle and below. Make the roof of iron or flat slate. In the center, do not forget to make a hole for supplying water to the mixer.
5. Close the sides of the shower.
6. Make the floor, it should be in the grate so that the water can drain well.
