To make the swing gates, you will need racks. The canvases will be hung on them. You can use a rolling profile or pipe with a section of 100×100 mm. The thickness of the pipe wall should be from 3 mm. It is necessary to purchase gate spinger and loops. Work starts with the installation of racks. The pipe hole is covered on top with a lining so that water does not get inside. In the lower part, a heel is fixed 250×250 mm and reinforcement, it will serve as anchors. Then the canopies are attached.
For racks make pits 60 cm deep. At the bottom, a solution of concrete is placed with a layer of 6-10 cm. To fix the rack, use stones and temporary spacers. Prepare a solution of concrete with the addition of crushed stone. Pits fill a little higher than soil level. Racks should be placed vertically and have one height.
The frame of the gate is made from the pipe 30×50. Also, for linings you will need steel with a thickness of about 2.5-3 mm. The pipe is marked and cut to the desired size. Welding is used to connect parts. To carry out the assembly of the structure, the parts are slightly “grabbed”, perform the fit and combine. After assembly, the skeleton boil all joints. To strengthen them, steel linings are installed.
After fixing the canvas, the gap between the lower part of the gate and the ground should be 5-8 mm. Then the lock is installed on the gate. The structure is painted with oil paint.
By tradition, before entering the house, we must shake off dust from clothes or water from an umbrella. To make it comfortable, it was customary to install the entrance visors that were decorated in every possible way and were a kind of “visiting card”. This tradition has been preserved. Here they will be made and installed.