Strong central workshop equipped with modern devices for control, peties, commissioning and research will allow you to carry out large adjustable and other work in factories, improve the coefficient of use of devices. Such a workshop can have a group for the repair of power plants: engines, starting equipment and others. The central workshop can be entrusted with the following work: repair of devices and automation installations, including the repair of pulsed and electric lines; supervision of control and measuring instruments and their poserka; presentation of devices on time for verification by the bodies of the Committee of Standards of measures and measuring instruments; manufacturing of non -standard equipment; conducting installation and adjustment work; The vertical location of the machines is widely used. Infinite rollback of trolleys using chains, not cables is used. Simultaneously with the load of trolleys, in their free time from their loading, clay is developed by excavators into the dump, for which there are dell conveyors on the excavators. Clay waterlogging is carried out in round suppressors. Runners are located at the top of the brick units. The final duplication of clay to molding humidity is carried out in the runners. All production waste is supplied to the runners without preliminary crushing. Under the runners are plate mixers with revolutions, allowing to maintain the continuity of the process during small stops. The widespread use of cutting and accommodation machines. The widespread use of electrical trolleys. Drying of products due to the distant heat of own power plants. Drying workshops are very saturated with instrumentation and mechanisms.