Plastic windows are considered the most popular window systems in the conditions of a sharp-specific climate. If a low temperature is observed throughout the calendar year, coupled with high humidity, then the conclusion is obvious – only plastic windows. But they can meet different. And the buyer should immediately choose and install the highest quality plastic windows in his own home.
The first thing you need to pay attention to choosing plastic windows in Irkutsk is a profile that is completely and completely made from the most practical material – PVC plastic, which can successfully resist negative or positive temperatures.
The width of the plastic profile in good systems should be all 58-70 mm. In the case when the manufacturer offers the customer a window with a width of not more than 50 mm, it must clearly and clearly understand that such windows are considered hopelessly outdated. They can only be used for technical rooms where noise insulation and temperature safety is not so important.
The thickness of the profile should be within-0.25-0.3 mm. This will allow him (profile) to maintain a high level of strength in relation to climatic influences. Especially at the corners, since it is not structurally impossible to install a galvanized P-shaveler in these places. Thus, plastic completely and completely takes on the entire load on the corners of the frames. When the manufacturer offers the customer profiles with a thickness of 0.2 mm, then again, it is recommended to use them for non -residential premises.
If there is a lot of air chambers filled with air or inert gas in the form of a six -fluorine sulfur or argon inside the profile, the better. It is important to pay attention to the tightness of air chambers. In case of improper assembly, window plastic profiles will remain cold in winter. And remake defective window systems not to introduce yourself to it.
Glass of plastic windows can be very different – with a width of 4 mm to 6 mm. But one of them should unite – this is a special polymer film that serves to delay infrared radiation from residential premises. Only in this case it will be possible to hope that the heat in the house will persist in the most effective way. Particular attention should be paid to seals. If earlier there were rubber seals in the wide range, now silicone or even polyurethane seals that have a greater softness and long life resource (they withstand for several decades) are increasingly popular.
When assembling a plastic window, all the necessary accessories are used – loops, locks and rotary mechanisms. If the fittings are the highest quality, that is, from famous European or even Turkish manufacturers, the plastic window will correctly serve for many decades. And the repair of the window, as often can be observed in the second year, if cheap Chinese accessories are used, you will not need.
Having chosen the right windows, there is no doubt that noise from the street will not penetrate the room, the house will be warm in winter and is not hot in the summer and, of course, safely all year round.