House heating costs can be significantly reduced by hearing your home with the help of heat -insulating plates. Thermal insulation of the house will protect the concrete base of the house from sharp temperature changes and will provide constant heat in your housing. Thermal insulation should have important criteria – such as increased resistance to deformation, low thermal conductivity, high fire safety coefficient, high paraopropriation.
Wall insulation has its own characteristics and nuances. The insulation for the facade must be selected non -combustible and with high vapor permeability. The stiffness for the facade plates depends on the material that was used when decorating the building. On the outer walls, the insulation is attached with dowels. If the facade is plastered, then, except for dowels, it is attached using facade glue. The glue itself is similar to cement, which is diluted with water before use. For the plastering facade, boards with paraoproprosa of at least 150 kg/cube are used. m. Insulation should not be allowed in two layers of such a facade. For the facade, which will subsequently be sheathed with siding, a minvat from basalt, which has a stiffness of more than 90 kg/cubic meters, is taken. cm. Plates on such a wall are attached in two layers. Thermal insulation Termaflex – excellent choice. For the roof, non -combustible thermal insulation material with high density is used. There are various types of roofs, each of which requires a separate approach during thermal insulation. The conduct of heat used during insulation of the material is selected depending on the type of roof. The main advantage of the use of mineral wool in front of other insulation is its resistance to mechanical damage. The internal walls of the house also require insulation. In the building of the insulation slab will carry a slightly different function, namely, they will isolate the premises from extraneous noise and create a favorable climate in the room. The thickness of the walls for walls for the maximum effect should have a thickness of 90mm. The stiffness of the plates can vary from 20 to 50 kg/cube. m and above. Foam polystyrene is used for floor insulation. The thickness of such plates will be from 50 mm. The laying of the plates is carried out in the same way to each other. A black screed is applied on top of the plates, and the finish.