When facing veneer, you can get interesting decorative effects. Here on a small panel, four veneer silt sectors and borders are made by means of a marginal knife and a well-tank, cut one part of the veneer and use it as a template for cutting the rest.
Cut very carefully, lay and adjust the four sectors using adhesive tape for veneer. Also swing all possible cracks in the veneer. Replace all cut pieces with adhesive tape. The adhesive tape for the veneer is moistened (you can with a tongue) and is easily removed after repeated wetting after applying the glue
Decorative applique pads and t. p. You can buy various sizes, shapes and with different patterns. This oval lining is laid in the center of the panel of the paper substrate up.
Gently cut the veneer based on. The lining is inserted into the space released from veneers, fixed with a tape and glued to the panel with paper, the press and clamp, the base is trimmed with the pasis so that the border is placed.
For the edging of the lined panel from the veneer, a border with fibers, walking across the length, is used.
Cut the bands of veneer for the curb, if necessary, connecting the ribbon to obtain the desired length, first adjust the edges of the lined panel, so that the place for the boron of the Dura can be formed around the perimeter of the bevel panel for the angular joint, by putting the curbs in place and carefully cut both each strip at the same time glue at the same time separately, using the tape and flat press.
Narrow strips with various patterns can very decorate the panel lined with veneer.
After the curb is glued and the maple is dried, the lined panel is ready to insert such a “belt” using a milling cutter with a straight guide ruler, you can make a very narrow groove around the panel {see milling). Use narrow cutters with great caution, since they should be very fragile depth of such a groove about 2 mm
The rounded corners of the grooves are aligned at a right angle with a chisel (cm work with a chisel/chisel) carefully prepare the belts, marking the corner bevels with a chisel then cut the belts on the blackboard
Apply a little PVA glue with a spatula or brush and carefully insert the belts for “pressing” the belts into the groove you can use a small light hammer.
After gluing, the panel is ready for the most pleasant – final stripping is best done in cycle (see. Cycle). First, the veneer is wetted with a damp cloth, and then it is cycated to open the beauty of the texture of the cycle tree works in all directions, but be careful, acting along the fibers and diagonally so that the cycle goes smoothly. Although the veneer is very thin, it surprisingly strongly resists cyclime. Now the panel is ready for finishing
Wooden products are not only aesthetic, they are often and useful; and the artistic expressiveness of the manufacturing methods can be an important aspect of their functionality. Most samples use several methods of carpentry work.
Examples of carpentry work demonstrated in this section, which include tables, cabinets, caskets, chairs and decorative products, were selected because they reflect some of the methods described in the first part of the book, and show the almost unlimited possibilities of their creative application.